Friday, January 4, 2013

PSP to Serial adaptor

 


The audio-serial PSP port is only 3.3V output level and can not be used directly to a RS232 device.

This adaptor acts as a RS232 level translator and provides a 5V voltage to connect some small devices.

All the needed files are included in the attached file:


PSP2Serial.sch : Schematics (Eagle 5.0.0)
PSP2Serial.brd : PCB (Eagle 5.0.0)
PSP2Serial-Pcb-lower.png : 600dpi 'Solder layer' (lower side)
PSP2Serial-Pcb.png : 600dpi full board
PSP2Serial-Pcb-Sch.png : 150dpi schematics

Usage
Just connect the board to the audio PSP port and the sub-9 connector to a RS232 device.

Enjoy !

Buzz

 Package

 

-

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.

Subscribe to: Post Comments (Atom)

Expansion shield for Arduino UNO

  Expansion shield for Arduino UNO Version : 14/04/2023 This little board and the source code are part of a CS Bomb-like project to be us...

  • Colecovision ROM Builder
    Version : 07/03/2023 Updated : 07/04/2023 Coleco ROM Builder is a Windows application to easily build ROM files for the 31-in-1 & 63...
  • Arduino thermostat
      Here is an "easy to make" Thermostat. The goal was to replace an existing non working thermostat on a heat accumulation panel....
  • Colecovision 63-in-1
    Original version: 28/01/2013 Update: 12/02/2023 The 63-in-1 is a multicart board for the ColecoVision. It is made to handle 63 rom file...